Workshop Front Door Pergola, Part 1 – Making The Decorative Brackets

So at the moment, I’m going to point out you ways I made the brackets for the pergola. I had initially deliberate to construct the brackets to match these on the facet door of the studio, however I modified my thoughts. I believe these brackets are too large and ponderous for the workshop. Plus, the 2 doorways can’t be seen on the similar time. Should you’re standing the place you possibly can see the workshop entrance door, there’s no method to see the studio facet door, and vice versa. So after deciding that wasn’t necessary, I simply went with a unique design that I actually favored.

I wished my brackets to be 31″ x 31″. So I began with a 2″x4″, and I reduce one piece to 29.5″ and the opposite piece to 31″. I sanded these rather well with 80-grit sandpaper with my orbital sander, after which sanded the corners by hand.

You may see above that the 2 items have a black mark on one finish. That’s the place I marked the place I reduce the two″x4″ to chop the 2 items. I marked these in order that I might put the bracket along with these ends collectively. Generally placing wooden items again collectively the place you chop them creates a greater match. It’s only a good observe to get into.